PC/ABS compounds
GRN-PCA-H320
- Brand GRN
- GREENPOLYMER compound
- Base resin PCA
- PC/ABS
- Focus H
- High impact
- Tier 3
- High-performance tier
- Sequence 20
- Development sequence 20
Low-temperature high-impact PC/ABS
Example grade / typical values — to be corrected by GREENPOLYMER
A pendulum breaks a notched bar supported at both ends; the energy it absorbs gives the result
Description
Suitable parts
- Power tool housings
- Shared-vehicle body panels
- Robot housings
Good low-temperature toughness.
Key features
Applications
Related industries
Other grades in this family
Parameters
Example grade / typical values — to be corrected by GREENPOLYMER
| Property | Typical value | Test standard |
|---|---|---|
| An illustration, not a measurement: Immersion method: weighed in air, then in a liquid; buoyancy gives the density | 1.12–1.15 g/cm³ | ISO 1183 |
| An illustration, not a measurement: Melt is pushed through a die at a set temperature and load; cuts taken at fixed intervals are weighed260 °C / 5 kg | 10–20 g/10 min | ISO 1133 |
| An illustration, not a measurement: A dumbbell specimen is pulled at a constant speed and the stress–strain curve is recorded until it breaks | 48–56 MPa | ISO 527-1/-2 |
| An illustration, not a measurement: A pendulum breaks a notched bar supported at both ends; the energy it absorbs gives the result23 °C; −30 °C: 25–40 kJ/m² | 45–65 kJ/m² | ISO 179-1/1eA |
| An illustration, not a measurement: A loaded bar is heated in an oil bath at a steady rate; the result is the temperature at which it reaches the set deflection1.80 MPa | 95–110 °C | ISO 75-1/-2 |
| An illustration, not a measurement: Horizontal burn: flame at the free end; does the flame front pass the end mark?1.5 mm; design target, subject to test report | HB | UL 94 |
Typical values. Refer to the actual TDS. Values are typical industry ranges for this material class, not GREENPOLYMER test data; to be corrected by GREENPOLYMER. Flammability rating, CTI, light transmittance and weathering: design target, subject to test report (for each grade).
Immersion method: weighed in air, then in a liquid; buoyancy gives the density
Contact us
Tell us about the part, material requirements, equipment and expected volume. We will recommend suitable grades and the validation data you need.