PA6 / PA66 compounds
GRN-PA6-E310
- Brand GRN
- GREENPOLYMER compound
- Base resin PA6
- PA6
- Focus E
- Glass-fiber / mineral reinforced
- Tier 3
- High-performance tier
- Sequence 10
- Development sequence 10
Glass-fiber-reinforced PA6 (GF30, non-flame-retardant)
Example grade / typical values — to be corrected by GREENPOLYMER
Three-point bending: the bar rests on two supports and is loaded in the middle; the initial slope gives the modulus
Description
Suitable parts
- Power tool housings
- Gearbox housings
- Handle frames
Balanced stiffness and toughness, oil and grease resistant.
Key features
Applications
Related industries
Parameters
Example grade / typical values — to be corrected by GREENPOLYMER
| Property | Typical value | Test standard |
|---|---|---|
| An illustration, not a measurement: Immersion method: weighed in air, then in a liquid; buoyancy gives the density | 1.34–1.38 g/cm³ | ISO 1183 |
| An illustration, not a measurement: A dumbbell specimen is pulled at a constant speed and the stress–strain curve is recorded until it breaksdry | 160–190 MPa | ISO 527-1/-2 |
| An illustration, not a measurement: A pendulum breaks a notched bar supported at both ends; the energy it absorbs gives the result23 °C; dry | 10–15 kJ/m² | ISO 179-1/1eA |
| An illustration, not a measurement: A loaded bar is heated in an oil bath at a steady rate; the result is the temperature at which it reaches the set deflection1.80 MPa | 200–215 °C | ISO 75-1/-2 |
| An illustration, not a measurement: Horizontal burn: flame at the free end; does the flame front pass the end mark?1.5 mm; design target, subject to test report | HB | UL 94 |
| An illustration, not a measurement: Three-point bending: the bar rests on two supports and is loaded in the middle; the initial slope gives the modulusdry | 8.5–10 GPa | ISO 178 |
Typical values. Refer to the actual TDS. Values are typical industry ranges for this material class, not GREENPOLYMER test data; to be corrected by GREENPOLYMER. Flammability rating, CTI, light transmittance and weathering: design target, subject to test report (for each grade).
Immersion method: weighed in air, then in a liquid; buoyancy gives the density
Contact us
Tell us about the part, material requirements, equipment and expected volume. We will recommend suitable grades and the validation data you need.