PA6 / PA66 compounds
GRN-PA6-E510
- Brand GRN
- GREENPOLYMER compound
- Base resin PA6
- PA6
- Focus E
- Glass-fiber / mineral reinforced
- Tier 5
- Flame-retardant tier
- Sequence 10
- Development sequence 10
Flame-retardant glass-fiber-reinforced PA6 (GFRPA)
Example grade / typical values — to be corrected by GREENPOLYMER
A flame is applied as specified; afterflame time and whether drips ignite the cotton below decide the class
Description
Suitable parts
- Brackets, housing frames, cost-sensitive structural parts
High stiffness, flame retardant.
Key features
Applications
Related industries
Parameters
Example grade / typical values — to be corrected by GREENPOLYMER
| Property | Typical value | Test standard |
|---|---|---|
| An illustration, not a measurement: Immersion method: weighed in air, then in a liquid; buoyancy gives the density | 1.40–1.50 g/cm³ | ISO 1183 |
| An illustration, not a measurement: A dumbbell specimen is pulled at a constant speed and the stress–strain curve is recorded until it breaksdry | 130–160 MPa | ISO 527-1/-2 |
| An illustration, not a measurement: A pendulum breaks a notched bar supported at both ends; the energy it absorbs gives the result23 °C; dry | 8–12 kJ/m² | ISO 179-1/1eA |
| An illustration, not a measurement: A loaded bar is heated in an oil bath at a steady rate; the result is the temperature at which it reaches the set deflection1.80 MPa | 190–205 °C | ISO 75-1/-2 |
| An illustration, not a measurement: A flame is applied as specified; afterflame time and whether drips ignite the cotton below decide the class1.5 mm; design target, subject to test report | V-0 | UL 94 |
| An illustration, not a measurement: Three-point bending: the bar rests on two supports and is loaded in the middle; the initial slope gives the modulus | 8–10 GPa | ISO 178 |
Typical values. Refer to the actual TDS. Values are typical industry ranges for this material class, not GREENPOLYMER test data; to be corrected by GREENPOLYMER. Flammability rating, CTI, light transmittance and weathering: design target, subject to test report (for each grade).
Immersion method: weighed in air, then in a liquid; buoyancy gives the density
Contact us
Tell us about the part, material requirements, equipment and expected volume. We will recommend suitable grades and the validation data you need.